Introdução
If your LG V40 ThinQ’s charging port is damaged, outdated, or not functional use this guide to replace it or as a prerequisite for many other repairs for this phone. This guide can help restore the charging port of the LG V40 Thin Q.
This guide requires the completion of two prerequisite guides before getting to the charging port. This guide requires the use of a iOpener, iFixit Opening Picks (Set of 6), Phillips #000 Screwdriver, and a Jimmy. The process is difficult and requires care to avoid damaging internal components. Follow each step closely and make sure to power off your device before starting and disconnecting from any external power source.
-
-
Use an iOpener or hairdryer to heat the adhesive on the back cover by rolling it up and down the back of the phone.
-
-
-
Use opening to pry the back cover away from the adhesive.
-
This can take some time. Be patient and go slowly.
-
-
-
Use the opening picks again to gently remove the back camera lens cover and fingerprint sensor off from the back cover.
-
-
-
Clean the back cover of any old adhesive by gently heating the area with the iOpener to soften the adhesive.
-
Use a cloth or cotton swab soaked in isopropyl alcohol to gently rub and dissolve the glue.
-
-
-
Remove the fourteen 15 mm-long Phillips #000 screws holding down the wireless charging coil and loudspeaker module.
-
-
-
With the opening picks, very gently insert and pry the battery slowly until it comes free from the adhesive and remove it.
-
-
-
Disconnect any motherboard connectors and lift the the motherboard up and out of the phone.
-
-
-
With an opening pick, gently pry out the charging port.
-
The part of the charging port highlighted is glued down and needs more careful work
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
