Introdução
This is a prerequisite guide! This guide is part of another procedure and isn't meant to be used alone.
Single step screen disconnect
-
-
Separate the screen from the phone.
-
Check that all screws are tightened and there are no loose parts.
-
Reconnect the screen and test your phone to make sure it works. Power it back down and continue reassembly.
-
Apply new adhesive where it's necessary after cleaning the relevant areas with isopropyl alcohol (>90%).
-
Follow this guide if you're using custom-cut adhesives for your device.
-
Follow this guide if you're using a pre-cut adhesive card.
-
Conclusão
To reassemble your device, follow these instructions in reverse order.
Be carefull after removing the screen to not lose the tiny gasket arount the proximity sensor, I suggest to remove it using a pair of twizers before the next step. That gasket is very important to ensure the correct behavior of the proximity sensor, without it it will read the screen as an obstacle and be always on
stefifox -