Garmin Nuvi 2599 Speaker Replacement

Use a T4 Torx screwdriver to remove the four 5.8 mm screws from the back of the device.

Insert an opening pick into the seam between the top and bottom case and slide it around the edge of the device to release the clips holding them together.

Insert an opening tool into the seam between the top and bottom casing, and gently pry them apart.

Use an opening tool or a clean fingernail to flip up the locking flap on the display cable—this is the unlocked position.

Use tweezers or your fingers to gently pull the ribbon cable out of its socket.

Remove the display assembly.

Use the angled tweezers to gently disconnect the battery connector from the socket on the motherboard.

Use a T4 Torx bit screwdriver to remove the four 5.8 mm screws from the motherboard.

Remove the motherboard.

Use a soldering iron to desolder the speaker connector from the motherboard.

Once the solder is liquid remove the wires from the motherboard and detach the speaker using a blue opening tool.