GameSir Cyclone 2 Bumper and Trigger Replacement

Escrito Por: Ross Debortoli
  • Comentários: 0
GameSir Cyclone 2 Bumper and Trigger Replacement

Dificuldade

Moderate

Passos

7

Tempo necessário

15 seconds - 20 minutes

Introdução

Follow this guide if you need to replace the triggers and bumpers in your GameSir Cyclone 2 controller.

  1. ThaKjTxgJTDrniuG
    ThaKjTxgJTDrniuG
    llgJCn3A61hDtpSq
    OjSn2oUcERRKJcJk

    • Use a T6 Torx to remove seven screws from the bottom of the controller.

    • The last screw is under the sticker. Lift the sticker with tweezers, then then remove the final screw.

  2. 6jkhrKTUpXsXaQ6Z

    • The two larger screws belong on the top two sockets of the controller

  3. WDQCwrdoDBjDx1uW

    • The remaining five sockets in these locations

  4. euvnAXorXLUp5tDN
    euvnAXorXLUp5tDN
    cAKKtlDlSFJE6PdF

    • The front plate should pop with minimal force with the D-Pad and action buttons becoming loose as well.

  5. oluHVwT5MOprclEi

    • once the face plate is off locate the top bumpers

  6. FJBNnGgWYBvFNaHa

    • The top bumpers are connected to the power button which you can just pull apart after removing two screws with the "00" Phillips bit

  7. GSfgH5OPY6DXdmrT

    • remove the bumpers and replace with the new set you have aquired

Conclusão

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler.

Autor(a)

Ross Debortoli

Membro desde: 17/10/25

325 Reputação

0 comentários