Introdução
If your EPOS Sennheiser GSP 302 headset has distorted audio, low volume in one ear, or no sound at all, the speaker driver may need to be replaced. For this guide, you will need to use a soldering iron to solder and desolder connections. Take care when handling internal wires. The process is the same for both the left and right speaker drivers.
Ferramentas
-
-
Hold the headset firmly with one hand.
-
Grip the edge of the earpad with your fingers.
-
Gently pull the earpad outward.
-
Work your way around the earpad, rotating it 360 degrees until it separates from the headset.
-
-
-
Gently scratch at the edge of the protective fabric layer covering the driver.
-
Carefully pull the fabric layer off, being mindful not to damage it in the process.
-
-
-
Remove the four 7.0 mm screws holding the speaker driver in place with a Phillips #1 screwdriver.
-
Carefully disconnect the speaker driver from the earcup by desoldering the connection with a soldering iron.
-
To reassemble your device, follow these instructions in reverse order.
