Introdução
If the microphone on your EPOS Sennheiser GSP 302 headset is experiencing issues such as poor voice pickup, isn’t recognized by a device, or produces static, this guide will help you replace it. For this guide, you will need to use a soldering iron to solder and desolder connections. Note that the microphone is located on the left earcup.
Ferramentas
-
-
Hold the headset firmly with one hand.
-
Grip the edge of the earpad with your fingers.
-
Gently pull the earpad outward.
-
Work your way around the earpad, rotating it 360 degrees until it separates from the headset.
-
-
-
Gently scratch at the edge of the protective fabric layer covering the driver.
-
Carefully pull the fabric layer off, being mindful not to damage it in the process.
-
-
-
Remove the four 7.0 mm screws holding the speaker driver in place with a Phillips #1 screwdriver.
-
Carefully disconnect the speaker driver from the earcup by desoldering the connection with a soldering iron.
-
-
-
Remove the four 5.9 mm screws holding the motherboard in place with a Phillips #1 screwdriver.
-
Lift the motherboard upwards and hold it off to the side so that the microphone screws can be accessed.
-
-
-
Remove the three 6.0 mm screws holding the microphone in place with a Phillips #1 screwdriver.
-
Remove the microphone.
-
To reassemble your device, follow these instructions in reverse order.
