Disassembling Nano 7/LINK (A/B/C-N Serial) Panels

Escrito Por: Kaffelogic
  • Comentários: 0
Disassembling Nano 7/LINK (A/B/C-N Serial) Panels

Dificuldade

Easy

Passos

5

Tempo necessário

5 - 10 minutes

Introdução

Removing the panelwork on any Kaffelogic Nano or Nucleus Link coffee roaster with an A, B, C or N prefix serial number.

Ferramentas

  1. nfvSoTpnU4ksHcg6
    nfvSoTpnU4ksHcg6
    6MBXn1MgnMby6MAZ

    • Remove the 6x 2.5mm Hex screws on the left and right side of the roaster.

  2. qHiOtnAKcXjbaGoV
    qHiOtnAKcXjbaGoV
    OTbSwheRLDR1RpCH

    • Hold the roaster steady while removing the plastic top/closure.

    • Panels may spring apart slightly once removed.

  3. 5HgQGHsOcGRtWytG
    5HgQGHsOcGRtWytG
    YsnjyWOviUPEAgsT
    eljWHIrc23oQeaUH

    • Remove the 4x 2.5mm Hex screws on the bottom of the roaster.

  4. bokl2m3pNTLZsgaj
    bokl2m3pNTLZsgaj
    vu3RZpeDAwj1xhOk
    bUSiSNcKCwSERKhY

    • Pull away the front panel carefully.

    • Take care not to damage the buttons while maneuvering the front panel.

  5. CjFpLJRcjntXBWtF
    CjFpLJRcjntXBWtF
    U6CP2AwbVHaHnrnW
    Qasmpv1ohW2EYEcf

    • Stand the roaster up again and pull away the rear panel from the chassis to expose the remaining components.

    • The mains cable is routed through the panel and it will remain attached, place the panel in a soft bag if you wish to protect the paint throughout the rest of your repairs.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Kaffelogic

Membro desde: 23/07/25

2356 Reputação

0 comentários