iPhone Air Battery Removal

Escrito Por: Nick Schultz
  • Comentários: 0
iPhone Air Battery Removal

Dificuldade

Moderate

Passos

7

Tempo necessário

No estimate

Introdução

  1. hlKLsmfQLOIRtqbk
    hlKLsmfQLOIRtqbk
    lIrOJmlRCRIxEABZ

    • The guide uses the VoltClip to release the adhesive. If you're using a different method, such as a 9V battery, follow the guide normally and supplement your power source's operating procedures during the necessary steps.

    • Plug the VoltClip's barrel connector into the USB-C elbow.

    • Don't connect the VoltClip to a power source just yet. The loose alligator clips may accidentally touch each other and cause an electrical short.

  2. otvXW6KqTKWmfZHK
    otvXW6KqTKWmfZHK
    pBM5av1EseWvLU6H

    • Use a clean fingernail or an opening pick to peel up one of the silver tabs on the battery.

  3. JuOcEYJpanaWYEbv
    JuOcEYJpanaWYEbv
    mNJJaTpgmKYrHAfK
    4uAClPcqEnpJGTYR

    • Attach the red alligator clip to the lifted silver tab on the battery.

    • Attach the black alligator clip to the grounding screw located on the left side of the bottom edge.

  4. ym4coFHOYxAUdMUu
    ym4coFHOYxAUdMUu
    2p2bhlwcQ26hU2Em
    SxgBBkPxcPFMS4ah

    • Make sure the red alligator clip is secured. If the black alligator clip pops off its screw, disconnect the USB-C cable, reseat the clip, and try again.

    • Connect the USB‑C elbow to a power source (via a USB‑C cable) and wait 90 seconds for the adhesive to loosen.

  5. HqD2BCj1HesPQxcX
    HqD2BCj1HesPQxcX
    2ICBSCuesZgPfE6x
    LVv2HPxRCIbYSFRh

    • Disconnect the USB-C cable from the elbow, then disconnect the alligator clips.

  6. 2mlVjP3pUJMNLFNF
    2mlVjP3pUJMNLFNF
    WGG1dqDCRtS2y4ZQ
    P1elJ1r1kKEGyN3m

    • Repeat this procedure on the other silver tab to loosen the second adhesive strip.

  7. vYycASJdllFLbBC6
    vYycASJdllFLbBC6
    RTQbqiuVcWmKL1XB
    6ujAv5JX5ZDikJAa

    • Apply a suction handle to the center of the battery and lift it out with slow, steady force to remove it.

    • If the battery doesn't come out easily, don't force it—reconnect the VoltClip for one minute on each adhesive strip.

    • During reassembly, if your replacement battery doesn't come with pre-installed adhesive, follow this guide to install it. Afterwards, follow this guide to install the back glass.

Autor(a)

Nick Schultz

Membro desde: 24/03/24

45909 Reputação

0 comentários