Yuneec Typhoon H Spring Clip Replacement

Escrito Por: Claire Luce
  • Comentários: 5
Yuneec Typhoon H Spring Clip Replacement

Dificuldade

Moderate

Passos

2

Tempo necessário

5 - 10 minutes

Introdução

The guide instructs you to replace the spring clip or (also known as the arm clip) at the arm attachment on the Yuneec Typhoon H.

The spring clips usually get broken during a crash.

  1. AVPYyyUwuqH12RFt
    AVPYyyUwuqH12RFt
    GhHAwoWZNDPK1WPj
    2R3GbYMrtLWBFPfg

    • Using a JIS #00 screwdriver, unscrew the 3mm oval screw.

    • The oval screw is hard to remove once fully unscrewed, to remove the screw flip the drone upside down to have the screw fall out.

    The screws are too small to put back in. There isn’t enough contact between the head and the tip of any screwdriver. Magnetic or not, the tip slips out of the head, then the screw falls and disappears. I’ve worked for days, got one of three screws in by putting gorilla glue on the tip. The threads don’t engage back into the hole the screw came out of. 3 days wasted on these tiny screws.

    Douglas Pratt -

    My screws are Phillips head, not oval. I’ve had several disappear and have to get more. The whole screw is about the size of a grain of sand

    Douglas Pratt -

  2. 6eb3DsXQCqKGZSIY
    6eb3DsXQCqKGZSIY
    Na2EKDi2wVFBRTjY

    • For this step the arm must be bent.

    • Remove the broken arm clip by pinching the metal top and then pull it out with an upward force.

    • The Blunt Nose Tweezers may be helpful in removing the arm clip.

    How did you get the broken piece out from under the screw?

    Richard Fuller -

    Take the screw out first, then the broken clip slides straight out.

    Good luck getting the screw back in.

    Douglas Pratt -

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Claire Luce

Membro desde: 16/04/18

371 Reputação

Um comentário

what function does the little screw have?

Ruud -