VTech Kidizoom Smartwatch DX2 Battery Replacement

Escrito Por: Jessica Richard
  • Comentários: 8
VTech Kidizoom Smartwatch DX2 Battery Replacement

Dificuldade

Difficult

Passos

9

Tempo necessário

15 - 30 minutes

Introdução

If your Smartwatch is not charging, and you tested the cables, then the battery may need to be replaced. This guide will show you how to do this.

  1. EKVLg1IxwZlA6eOc
    EKVLg1IxwZlA6eOc
    IiEZa45iM5ufg5OJ

    • Begin by flipping the watch over with its back facing upwards.

  2. 3yiLtcFNUTvoOOth
    3yiLtcFNUTvoOOth
    2IgCRMAdgWPBkPKM

    • Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

  3. JHvLq1CKc6MjIJQ3
    JHvLq1CKc6MjIJQ3
    jdD3vgVU4MAZ6RcK

    • Gently lift the backplate up to remove it.

  4. 4NxGTlsNTmlFS3Ed
    4NxGTlsNTmlFS3Ed
    IQqVPFhTtAPtp5DX
    Jd6a3ehGhcdoLRE1

    • After removing the backplate, lift the master switch up from the circuit board.

  5. W6ctQJhA1IlPcIBY

    • Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

  6. BieEUtJaqFpuPUQ1
    BieEUtJaqFpuPUQ1
    6oGFBLqRLnNDVMqH

    • Carefully remove the speaker from the case without disconnecting it from the motherboard.

  7. Br1lPyALvmaUrJ5W
    Br1lPyALvmaUrJ5W
    QM1PEwyfxbrNYCLy

    • Using the tweezers, carefully lift the bar holding the connection to the screen.

    • Remove the motherboard from the device.

    and how to put it back

    noah -

    I'm trying to replace the microphone. Will replacing the motherboard get me a new microphone? I don't see it listed as a replacement part.

    Bill Pasnau -

  8. fI5U3naCOn3Qxpdj

    • Carefully pry the battery off of the circuit board using the plastic opening tool.

    how do you swich the battery

    Nathan Snyder -

  9. GZAljmtpRRX4EnoC

    • De-solder the wires connecting the battery to the circuit board.

    • Remove the battery.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Jessica Richard

Membro desde: 25/10/18

515 Reputação

5 comentários

Hey guys, My VTech watch is plugged in but once I turn it on it does but then shows a dead battery. I actually didn’t play with it for a while and I left it dead battery.

Gabriel Baker -

So I might try this trick and see if it works.

Gabriel Baker -

Sometime i’ll try it

Gabriel Baker -

when I have the right tools

Gabriel Baker -

Can I cut the wires connected?

TECH DUDE -