ThermoPro TP50 Digital Hygrometer Indoor Thermometer Fixing Cut Wires

Escrito Por: Carlos Contreras
  • Comentários: 0
ThermoPro TP50 Digital Hygrometer Indoor Thermometer Fixing Cut Wires

Dificuldade

Moderate

Passos

7

Tempo necessário

30 - 50 minutes

Introdução

This guide is meant to teach how to repair cut wires on the Thermopro TP50 Indoor Thermometer. In this repair guide, you will be required to solder. The wires inside this device may snap from the device wearing out or if handled too roughly, which will make the device incapable of turning on. Soldering the wire will restore this device to performing as normal and powering on.

  1. MVrfYL2OnPb6loTw
    MVrfYL2OnPb6loTw
    LRiWBNhtLQcOPYZA
    yO5vT4fq2dGpRpFT

    • Turn the ThermoPro TP50 over, so that the screen faces down.

    • Remove the battery cover.

    • Remove the battery.

  2. eXMjrT5cAy2AFqOM
    eXMjrT5cAy2AFqOM
    oWffAbXPqWXDtHnE
    igcLnYWu4LuGWrKM

    • Use a Phillips screwdriver to remove the screws in each corner of the back.

  3. yALdDxR6lkQ3arks
    yALdDxR6lkQ3arks
    OHArubWRBYoSc3jY

    • Remove the back cover of the ThermoPro TP50.

    • Be careful during this step, as the wires inside can break.

  4. gkFjCUjTBsFs1IkR
    gkFjCUjTBsFs1IkR
    nQqVRtAX4iNG12ON
    1fxBPVtuQrSWftte

    • Using a Phillips screwdriver, remove the five screws holding down the circuit board.

    • When the screws are removed, grab the circuit board and lift it off the device.

  5. WcQmYv3E3wLW4jDi
    WcQmYv3E3wLW4jDi
    X1CgVp4KJ11iP1WB

    • Grab the wire that needs to be soldered.

  6. rC4lwsoBQCCWpTXw
    rC4lwsoBQCCWpTXw
    4UZU3gRMRg32NXLL

    • Use a wire stripper to remove the insulation of the wire.

    • Make sure to only remove a small portion of the insulation at the end of the wire. This will ensure the wire is still long enough to be soldered.

  7. HeB5NQnXYJl3SXwo
    HeB5NQnXYJl3SXwo
    keILNRQZ3JSIDhv3

    • When the solder is hot, place it over the wire and metal prong.

    • Do not hold the solder over the wire and prong for too long, as you can melt the metal.

    • Be careful using this tool, as it can lead to burns or injury.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Carlos Contreras

Membro desde: 28/08/25

145 Reputação

0 comentários