Introdução

The Sony VAIO PCG-933A keyboard is an important component of your laptop, and if it's not functioning well, it might need to be replaced. Possible reasons for needing a keyboard replacement include:

  • Keys that are stuck, loose, uneven, unresponsive, or producing the wrong character
  • Faded or worn letters on keys
  • Missing keys
  • General wear and tear

If you encounter a problem with your keyboard, this guide can be used to walk you through the replacement process.

Before you begin the repair, make sure to power off your laptop and unplug it from the power adaptor and all peripherals.

  1. CUVFCtgY1TQKE1iX
    CUVFCtgY1TQKE1iX
    QEqJlCOLBmdhiYVr
    • Turn the laptop upside down so that the top is sitting on a flat surface.

    • If you are looking at the bottom of the laptop the battery is located on the front right side of the laptop; the opposite side from the floppy disk drive.

  2. 1tYS1WR6wtqfinhe
    1tYS1WR6wtqfinhe
    2wdBD6LtMTMiljRG
    u5mRNT1JjSCk5BHV
    • As shown by the arrow, slide the plastic cover up and then pull out and downwards.

    • You should now be able to pull the battery out.

  3. FRtpnBjByKweCVcu
    • Remove the four 16 mm screws bordering the edge of the laptop using a Phillips #0 screwdriver.

  4. KXOGv2FaoTklELXQ
    KXOGv2FaoTklELXQ
    5ciUJN2WmZHhZav2
    • Remove the 4mm screw on the right rear side of the laptop next to the audio ports using a Phillips #0 screwdriver.

    • This will release the speaker grille.

  5. ZECXoRl6GWvjURVi
    • Flip the computer so the key board is facing up.

  6. xKqZeybCTQ5fqvAg
    xKqZeybCTQ5fqvAg
    LnNfhWtlwqZd2LLP
    BFRdhjnepaM5iUjd
    • Slide the blue speaker grille (located above the keyboard) to the right and gently pull upward. The grille will still be connected by a white electrical strip.

    • Carefully pull out the white electrical strip. By doing this you will remove the speaker grille.

  7. TrHfTI2UZ2ta1biR
    TrHfTI2UZ2ta1biR
    IjSMPaU2BOPPaXff
    j1ZB65kdppUgocVy
    • Remove the 4mm screw in the center using a Phillips screwdriver.

    • Carefully and slowly pull the green strip straight up (away from the laptop) to disconnect it. Make sure not to pull too hard to avoid breaking.

    • The keyboard can now be removed.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Sara Lillard

Membro desde: 11/04/11

165 Reputação

0 comentários