Introdução
This is to access and replace the audio jack for the Sennheiser Momentum 4 Headphones. This can be done with a 00 Phillips head screwdriver, nylon tweezers, plastic spudger, and IFixit opening tool.
-
-
On the right ear piece, insert an opening tool into the gap between the ear pad and the driver housing.
-
Gently pry the ear pad away from the driver housing until the ear pad fully releases.
-
Remove the right ear pad.
-
-
-
Use a Phillips #00 screwdriver to remove four 6.5mm screws that secure the right driver housing.
-
-
-
Insert a spudger into the seam between the driver housing and chassis.
-
Gently pry the driver housing up and out of the chassis, with care not to strain the connected cables.
-
-
-
Flip up the three black ZIF locking flaps that secure the three bronze ribbon cables.
-
Disconnect all three ribbon cables.
-
-
-
Use a Phillips #00 screwdriver to remove the two black 1.4 mm screws that secure the I/O board.
-
Lift the I/O board up and out.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
Um comentário
So can we buy the I/O port replacement?