Sceptre X9 Komodo VII Power Supply Unit Replacement

Power off and unplug the monitor before starting.

Place the monitor face down on a soft, flat surface (such as a towel) to protect the screen.

Using a Phillips #2 screwdriver, remove the four 11.5 mm screws securing the stand.

Gently pull the stand out to detach it from the monitor. - Caution: Do not force the stand out. If it resists, check that all screws have been fully removed before pulling.

Using the same Phillips #2 screwdriver, remove the two 11.5 mm screws securing the plastic bar.

Lift the bar away and set it aside.

Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

Pry the monitor using the plastic opening tool to release the clips holding the cover on.

Once all the clips have been released, remove the cover by pulling it up.

Using the #2 Phillips screwdriver, remove the one 6mm screw.

Unplug the indicated cable by pulling on the base.

Slide the cover toward the top of the monitor.

Remove the cover.

Using a #2 Phillips screwdriver, remove the two 4.72 mm Phillips screws that hold the power adapter in place.

Unplug the seven connections from the power supply unit by gently pulling on them.

Using a #2 Phillips screwdriver, remove the screws and the wire that is attached to the ground.

Four 6 mm Phillips screws

One 8 mm Phillips screw

Lift the power supply unit straight up to remove it from the back panel.