Samsung Galaxy S7 Active Rear Camera Replacement

Escrito Por: Joe De Leone
  • Comentários: 0
Samsung Galaxy S7 Active Rear Camera Replacement

Dificuldade

Moderate

Passos

13

Tempo necessário

40 minutes - 1 hour

Introdução

This guide will teach you how to replace the rear camera on the Samsung Galaxy S7 Active.

  1. AdwfmWKHNLomBYXm

    • Melt the adhesive on the screen by applying a blow dryer directly on the screen.

    • Your phone is hot, please do not touch it with your bare hand.

  2. n6RgCfPhK3LHEtrY

    • Wedge the metal spudger in between the screen and the frame to begin separating them.

    • It would be easier to separate the screen from the sealing adhesive on the frame if you do it with more than one metal spudger.

    • Your phone might no longer be watertight after you reassemble it.

  3. uFo35fyJuyccAMbA
    uFo35fyJuyccAMbA
    ARAOdEP1KTrDPUiu

    • Slide the metal spudger around the phone at least once.

    • It would be easier to slide your metal spudger if you apply the blow dryer to where you are currently sliding.

  4. wOu5iIFBnIkde4ac

    • Lift the screen up with your hands.

    • Please wash your hands thoroughly with hot water and soap after you finish.

  5. yLol6PWCZB1u2FuB

    • Use a Phillips #000 screwdriver to remove a single screw.

  6. RQNjEgWihNBTFIEn

    • Use tweezers to remove the small plastic cover you just unscrewed.

  7. uFJTX6TsBxyalmDa

    • Use tweezers to remove the other small plastic cover.

  8. kKMBJX1YAJCyQcyX

    • Use a Phillips head #000 to take out the eleven screws marked in the photo.

  9. 4qdyaEQXaiXEDQmK

    • Use tweezers to disconnect the marked pieces from the motherboard.

  10. Ef61fbNo4VxU5YrR

    • Use tweezers to take out the middle button and its connection to the motherboard.

  11. DqsKGB3C6BTeCcs1
    DqsKGB3C6BTeCcs1
    WV5btLQ2bdiPwaVf
    SBoQpxBbtyCHumrf

    • Use a metal spudger to pull the mid frame and battery off of the motherboard.

  12. LfT1MNULHMCOkk16
    LfT1MNULHMCOkk16
    qeIShjRRfs3tKOhh

    • Use a spudger to remove the battery from the midframe.

    • To install a new battery and adhesive, follow this guide.

  13. Xr2x3ZLcaARww5Xw

    • Use tweezers to disconnect the front camera from the battery.

    • The connector should unsnap similar to a lego piece.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Joe De Leone

Membro desde: 18/04/18

310 Reputação

0 comentários