Repairing Black and Decker BL3000S Power Cord

Escrito Por: Elmer Pres Urbano
  • Comentários: 2
Repairing Black and Decker BL3000S Power Cord

Dificuldade

Difficult

Passos

7

Tempo necessário

15 - 20 minutes

Introdução

  1. XP1pNksXIg1JuZiu
    XP1pNksXIg1JuZiu
    mLjpsoHSZOE3dVUA

    • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

    • Lift the jar straight up from the base without tilting the jar.

  2. SdajC3TWRuQLTsF1

    • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

  3. OFskxagS5s2sMh1S
    OFskxagS5s2sMh1S
    WkxxOcS5KSCrRQFH

    • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

    • This provides access to the base screws beneath.

  4. V2qRJCVqgwuJVHQE

    • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

    • Both screwdrivers must have a minimum of a three inch shank (length).

    • Screwdrivers with extenders will not fit down the access holes.

  5. mWFNnbdsILQ6UMoR

    • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

    Ja, en nu hoe repareer ik de blender motor, 400 watt

    Deze is waarschijnlijk doorgebrand. Ik heb hem wel stil gezet toen er rook uitkwam, hij is dus niet beveiligd, maar dat heeft niet geholpen. Uiteindelijk is ie ermee gestopt. Het is een sokany 400 watt

    olijfjes -

    Ik heb niet meteen zo’n mooi printplaatsje visueel als ik deze openmaak, maar de ventilator.

    olijfjes -

  6. O3WZnQIHan5bPOCD

    • Tug on wires in the marked locations to make sure they are secure.

    • If the wire stays still, the connection is secure.

    • If you still have problems with the blender, it is probably a problem with the motor. Since the motor is irreplaceable, you will have to order a new blender.

  7. xdncMMxqXXBPnvrV

    • If the wire comes off, the connection is insecure. You will need to solder the connection to make it solid again.

    • If you don't know how to solder, here is a link to show you how. http://www.aaroncake.net/electronics/sol...

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Elmer Pres Urbano

Membro desde: 05/10/12

164 Reputação

0 comentários