Introdução
This is a guide on how to replace the daughterboard in a PDP Victrix Gambit Prime Wired Tournament Controller; this is useful if your daughterboard is broken. Signs of a malfunctioning daughterboard are low voltage, fluctuations in temperature and the controls not responding.
Ferramentas
-
-
Pull up and remove the Directional-Pad from the front case.
-
Pry between the front case and back case.
-
Remove the front case.
-
-
-
Use a Philllps #000 screwdriver remove the seven 9 mm screws holding the midframe.
-
Remove the midframe from the back case.
-
-
-
Use a Phillips #000 screwdriver to remove the four 6 mm screws from back triggers.
-
Remove the bottom triggers covers.
-
-
-
Remove the divider piece off of the daughterboard.
-
Use a Phillips #000 screwdriver to remove the three 6 mm screws securing the daughterboard.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
