Olympus D590 Motherboard Replacement

Escrito Por: Sara
  • Comentários: 0
Olympus D590 Motherboard Replacement

Dificuldade

Moderate

Passos

10

Tempo necessário

15 - 20 minutes

Introdução

The Olympus D590’s motherboard deals with the logical computation of the camera’s system. For users who are experiencing frequent system crashes, power issues beyond the battery, or wear and tear, this guide will address these issues. Additionally, replacing the motherboard will increase the performance and enhance its data safety.

No special skills are required to perform this replacement.

  1. tLRBDCXKkV3QFXxf

    • Remove five baseplate screws using a Phillips #00 screwdriver.

  2. xviXHOyDMDQNLxqv

    • Press and slide the battery cover retainer clip to the left. Use tweezers to lift the battery cover away.

  3. HbI3KlmFdDtXiqWg

    • Remove the single screw from the battery housing using a Phillips #00 screwdriver.

  4. w6ZLPFeFtDTHba5h

    • Using tweezers, lift the rubber plate to expose the ports.

  5. lWpwRWBLQLbGXt4r

    • Remove two screws from the ports using a Phillips #00 screwdriver.

  6. TrqgK4nV5sZBYJOi

    • Use a spudger to pry the faceplate away from the rest of the camera.

  7. cCr4mQVeNcIX6Qbl

    • To avoid disconnection of the connector line to the motherboard, use caution when pulling faceplate away from camera case.

    • Damage to the connector line will prevent the on/off power switch's operational function.

  8. DUugbvk5iiA1Z6h2

    • Remove four screws holding the motherboard to the internal housing component using a Phillips #1 screwdriver.

  9. IdDWIH2BMOIaAs4Q

    • Be cautious of the wires attached to the motherboard.

    • Remove the motherboard from the internal housing component.

    • Do not completely lift the motherboard out with the wiring connected. The wires must be disconnected before proceeding. The next step will demonstrate disconnection process.

  10. QRPNt1wjx6YPFEVR
    QRPNt1wjx6YPFEVR
    cVykpxcKZqiunVhw
    fKYSGf5yCrjwUsYX

    • Use rounded tweezers to disconnect the three wiring strips from the motherboard.

    • Using sharp tweezers may tear wiring tape and wires.

    • Use gentle force when wiggling or pulling wiring tape and wires to disconnect from the motherboard.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Sara

Membro desde: 15/04/10

84 Reputação

0 comentários