Nissan 350Z Tail Light Replacement

Escrito Por: sddale
  • Comentários: 0
Nissan 350Z Tail Light Replacement

Dificuldade

Moderate

Passos

8

Tempo necessário

25 - 45 minutes

Introdução

In this guide, we demonstrate the process of replacing a broken tail light on a Nissan 350Z. The primary function of a taillight is to create visibility for those behind you and signal what actions you are going to perform such as braking, making a turn, and backing up.

Having a broken taillight creates a hazard for others behind you and could lead to being ticketed due to the lack of visibility to your vehicle.

Before you begin the repair, make sure that your car is off and in park.

  1. ufAmpkKyWiQQCysn

    • Unlock and open the trunk.

    • The button is located right above your license plate.

  2. LxducB1QrTsVAqw3
    LxducB1QrTsVAqw3
    SIjqr4yNRe15YBC1

    • Look for the 3 bolts that secure the tail light to the car.

    • Attach your 10MM socket to your 1/4 inch ratchet.

  3. TXLVrhGC64oUtYtV
    TXLVrhGC64oUtYtV
    4hL6lTmNNSs4fjju

    • Using your 10MM socket and 1/4 inch ratchet remove the three bolts.

    • Make sure to keep the bolts together and in a safe place.

  4. VLbXfUeicTZLrfRs

    • Hold both ends of the headlight and carefully remove the assembly.

    • You may need to use some force when pulling, as dowel pins secure it to the car.

    • You can flip the tail light over and place it in the tail light cavity so you do not have to hold it.

  5. JS3qDofTbMfrR2Ov
    JS3qDofTbMfrR2Ov
    IohVxB4nTbe4PCrd
    D2Yh5XWHF5OPASV6

    • Check the underside of the connector for a square-shaped slot.

    • Insert your flathead screwdriver into the square tab to disconnect the connector.

    • If you are having trouble with this part, try to push the tab in then down.

  6. ThbWAFblUmcAso4P
    ThbWAFblUmcAso4P
    BofIMtZGmeAvAGQO

    • Reconnect the tail light cable connector to the new tail light assembly.

    • Press the connector firmly into the socket to ensure a secure connection.

  7. yrHScjXnbcfZfX6e

    • Align the dowel pins to allow the light assembly to seat itself safely.

  8. gp3gVcesRPHruliy
    gp3gVcesRPHruliy
    hFWfKVl1NIupgboi

    • Replace the bolts and use your hand to tighten the bolt just a bit.

    • Use a ratchet with the 10 mm socket to tighten the bolts fully.

    • Avoid overtightening the bolts, as this can make it harder to remove them the next time you need to replace the tail light.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

sddale

Membro desde: 12/05/25

157 Reputação

0 comentários