Nikon Coolpix S220 Accessing the Motherboard

Escrito Por: Shauna
  • Comentários: 1
Nikon Coolpix S220 Accessing the Motherboard

Dificuldade

Moderate

Passos

10

Tempo necessário

10 - 15 minutes

Introdução

This guide will show how to access the motherboard which will give you the ability to remove the lens and flash.

  1. TtOJYPG2fP3hxaTD

    • Remove the two 2.8 mm screws on the left side of the camera.

  2. DfD4kSCQJAqCP3cA

    • Remove the four 2.8 mm screws on the right side of the camera.

  3. ddUtZJHUb1nWWKFc

    • Remove the three 4.1 mm screws on the bottom of the camera.

  4. YDPFYhpjqMh55AaR

    • Gently lift the rear cover from the camera.

  5. VpmbtLIVJJHeiJOK

    • Gently lift the screen out of its place.

    • You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

  6. 2mvWZsq33mthc3Rf

    • Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

  7. bXFkarVdNrLGZCTw

    • Slowly pull the screen from the camera.

  8. SRYMpcvcQLVkvnUq

    • Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

  9. mSwCqFZs6JsPpRF1

    • Lift up silver LCD base plate

  10. YYEqRUIBUitERWIA
    YYEqRUIBUitERWIA
    oRDMiEmWQysGOTBZ

    • Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.

    • Slide the button panel ribbon cable out of its socket on the motherboard.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Shauna

Membro desde: 05/04/11

822 Reputação

Um comentário

It would be nice to have a guide for replacing the flash capacitor.

danwat1234 -