Mac Pro Late 2013 Power Supply Assembly Replacement

Escrito Por: Andrew Optimus Goldheart
  • Comentários: 3
Mac Pro Late 2013 Power Supply Assembly Replacement

Dificuldade

Moderate

Passos

5

Tempo necessário

No estimate

Introdução

Prereq only.

  1. UshNodOHDMceXpFZ

    • Flip the Mac Pro back over and set it gently on a flat surface.

    • We recommend laying the Mac Pro on the corner of the heat sink and the two standoff screw posts that attach to the interconnect board.

  2. DQHQqK22DDBykevM
    DQHQqK22DDBykevM
    OVnch6rGY1LfEWaj

    • Remove the two 3.6 mm T5 Torx screws from the sides of the power supply cage (one on each side).

    those are t4 screws in my mac

    Andrzej Kiryluk -

    T4s on mine, as well

    rwcinmsp -

  3. vF6SluHbFoM1FfJJ

    • Remove the power supply cage from the top of the power supply.

    • By removing this cage, you are exposing internal components of the power supply. Be very careful not to touch any of the power supply components or circuitry.

    • Be careful not to drop any screws or tools into the power supply, as this may damage the power supply.

  4. LUW6dka1INJTMWM4

    • Remove the four 5.5 mm T8 Torx screws securing the power supply assembly to the Mac Pro.

    On my Mac-Pro the 4 screws holding the power supply assembly in are T9, not T8...

    Billy -

  5. k435bScZ2IVpLdyI

    • Remove the power supply assembly from the Mac Pro.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Andrew Optimus Goldheart

Membro desde: 17/10/09

513614 Reputação

0 comentários