Logitech Zone 305 Battery Replacement

Power off the headset and unplug all cables.

With one hand, firmly hold the ear cup steady.

With your free hand, slowly pull the ear pad away from the cup until it slides completely off its plastic lip.

Remove the ear pad from the ear cup.

Insert the point of an opening pick into the seam between the speaker plate and ear cup.

Slide the pick along the seam to release the four speaker plate clips.

Use your fingers to move the speaker plate towards the right side of the ear cup so you can access the screw.

Use a Phillips screwdriver to remove the 7.1 mm‑long pancake screw securing the speaker housing.

Align the speaker plate to the speaker housing and squeeze firmly to engage two of the four clips.

Use your fingers to grab the speaker housing from the back.

Pull firmly to pop the housing off from its ball joint.

Use a Phillips screwdriver to remove the three 5.3 mm‑long screws securing the midplate.

Insert an opening pick in the seam between the midplate and the ear cup.

Twist the pick to loosen the midplate.

Use your fingers to swing the midplate away from the ear cup.

Slide the tip of an opening pick under the battery and pry gently to separate it from the midplate.

Use your fingers to peel and remove the foam pad covering the circuit board.

Store this pad in a clean location for reassembly.

Use angled tweezers to grip the edges of the battery connector.

Gently rock the connector side-to-side and slide the battery connector out of its socket.

Remove the battery.

Cut and attach a small strip of double-sided tape onto the battery.

Remove the liner to expose the adhesive.

Use your fingers to slide the battery connector fully into its circuit board socket.

Place the foam pad over the circuit board and use your finger to press it in place.

Align the battery in the midplate recess such that the battery cable reaches its circuit board connector.

Use your fingers to press the battery onto the midplate.

Swing the midplate back in place over the ear cup.

Use a Phillips screwdriver to install the three 5.3 mm‑long screws to secure the midplate.

Use your fingers to unclip the speaker plate from the housing.

Align the speaker housing to the midplate such that the speaker wire threads through both parts without twisting.

Align the ball joint to the speaker housing's center cutout.

Use your fingers to firmly press the speaker housing onto the ball joint to pop it back in place.

Use a Phillips screwdriver to install the 7.1 mm‑long pancake screw to secure the speaker housing.

Use your fingers to move the speaker plate back over the speaker housing.

The top clip is wider than the rest of the clips. Use this to help align the speaker plate to the housing.

Use your fingers to squeeze and engage the four clips to secure the speaker plate to the housing.

With one hand, firmly hold an ear cup steady.

With your free hand, place the pad over the top of the cup, so the fabric flap slips over the cup's plastic lip.

Thread the rest of the flap over the lip, working your way around the entire cup. Gently stretch the pad as necessary.

Check the entire perimeter of the cup to make sure the ear pad is fully on. If any of the fabric flap is sticking out, try to push it over the lip or remove the ear pad and try again.