Logitech G920 Driving Force Back Pedals Replacement

Escrito Por: Aiden Muse
  • Comentários: 1
Logitech G920 Driving Force Back Pedals Replacement

Dificuldade

Moderate

Passos

10

Tempo necessário

No estimate

Introdução

This replacement guide will help you in replacing a faulty or broken back pedal on the Logitech G920 Driving Force. The following steps can be used for any of the three pedals that need to be replaced.

  1. HF4HkR2RmkelbnGq

    • Locate the pedal you need to replace.

  2. kHKFGTLjhYjEOFd4

    • Use a Hex 2.5 screwdriver or Allen key to remove the two 30 mm center screws in the pedal.

  3. ZjXwgQUZ1ujJ2hoq

    • Remove the pedals from their stand.

    • Repeat steps 2-3 until all pedals needing replacement are removed.

  4. cmOtOVProCoqePeS
    cmOtOVProCoqePeS
    LHK34YKXOnxAwfPW

    • Remove the 12 12mm screws from the bottom of the device using a Phillips #1 screwdriver.

  5. ks2mBqU4yaRYRSNt

    • Remove the eight 12 mm screws from the bottom of the device with a Phillips #0 screwdriver.

  6. mAreZ1E5SHF4Y4Hc
    mAreZ1E5SHF4Y4Hc
    uviybMBn1UhPDDyB
    pVJIfNPPBX4OcqUR

    • Push down the switch found in the hole at the top of the underside of the pedal board.

    • This opens the carpet-hold to access more screws.

  7. BCkiXxnRBkFOadA2

    • Remove the two 14 mm screws behind the carpet hold with a Phillips #0 screwdriver.

  8. YIsZUDWYZtgJBDaa
    YIsZUDWYZtgJBDaa
    4PKFBW2ipFpk3Qac

    • Remove the pedal back that matches the pedal front removed in step 3 .

    • This image is not upside down. When removing the back panel piece, the lettering on the inner pedal mechanism will appear this way.

  9. ANSUi5bf3KoZwl3e
    ANSUi5bf3KoZwl3e
    oD1U4vUEjOypWvLB

    • Remove the washer and bolt at the top of the red piece on the pedal back.

  10. eZyFZvLa55qbRHXG
    eZyFZvLa55qbRHXG
    tExxCJuiG1RJVi3L
    sCdMsKGb6Ux5MHtc

    • Remove the red piece, spring, and block within the pedal back.

    • Replace the necessary part.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Aiden Muse

Membro desde: 12/09/23

594 Reputação

Um comentário

My set of pedals has an issue of continuously press break pedal, any idea what it can be? When I lift them into vertical position (holl base) it stops, but the again as horizontal (ready to be use) in the games like Forza EuroTruck Assets... etc, system behave as break pedal is press.

Olaf Tomczynski -