Lenovo V15-ADA Back Panel Assembly Replacement

Escrito Por: Tyler Kelly
  • Comentários: 0
Lenovo V15-ADA Back Panel Assembly Replacement

Dificuldade

Moderate

Passos

2

Tempo necessário

2 - 5 minutes

Introdução

To make any repairs on the Lenovo V15-ADA device, you must take the back panel off first. Below are the steps to remove the back panel.

  1. Y1nuV61TsLdGZVS5
    Y1nuV61TsLdGZVS5
    JeGFQDyDZMFDth4I

    • Remove the 10 marked screws using a Phillips #1 screwdriver from the back plate.

    • M2.5 × 7 mm, Phillips-head (6) (RED circles)

    • M2.5 × 4 mm, Phillips-head (4) (ORANGE circles)

    • The red circles show the longer screws, and the orange circles show the shorter screws.

    • Keep your screws organized. They’re different lengths and must go back in their original positions.

  2. raWXMOxLK4ORVVmw
    raWXMOxLK4ORVVmw
    tP2ii2LyDa3jAUkr

    • After removing all ten screws, use a plastic spudger to separate the bottom cover from the laptop.

    • Gently slide the tool around the edges until the clips begin to release.

    • Once all the clips are loose, lift the cover off and set it aside.

    • The Wi-Fi card is located near one corner of the motherboard. It has two antenna wires connected to it (one black and one gray).

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Tyler Kelly

Membro desde: 20/02/24

139 Reputação

0 comentários