Left Joy-Con 2 Battery Installation

Escrito Por: Nick Schultz
  • Comentários: 0
Left Joy-Con 2 Battery Installation

Dificuldade

Moderate

Passos

4

Tempo necessário

No estimate

Introdução

  1. MLLsQtCbWujhGA1D
    MLLsQtCbWujhGA1D
    uO3MubgmZX5D4jRH

    • Apply isopropyl alcohol to a cotton swab and wipe any adhesive residue from the frame.

    • The foam on the inside walls of the frame dissolves in isopropyl alcohol. Avoid damaging the foam.

  2. mDK3cPwVPhPwBiDQ
    mDK3cPwVPhPwBiDQ
    IPLPVauwORquGWSZ
    vhtLYBIZLMBN2i3j

    • If your replacement battery includes new foam, skip this step.

    • Slide an opening pick or fingernail between the foam and the battery, making sure it's completely below the foam's adhesive.

    • Carefully peel the foam sticker, including its adhesive, off the old battery. Avoid stretching or tearing the foam.

    • If the foam does tear, apply the pieces to the replacement battery in their original shape.

    • Apply the foam sticker to the new battery so the edges of the foam are aligned with the edges of the battery.

  3. 4pALAV6RcOrVDmqg
    4pALAV6RcOrVDmqg
    JwUpL3CuFiKKFJp5
    AbsbSeSDPIVtpvsS

    • If your replacement battery came with adhesive pre-installed, peel off any adhesive liners.

    • If your replacement battery doesn't include new adhesive, use thin, double-sided tape instead. If you're using our pre-cut card, cut one of the 5 mm strips so it's half as long, and apply the strips to the back of the battery.

    • Align the battery with its housing. Ensure the battery cable lines up with its channel.

    • Lower one side of the battery, then the other, into its housing.

    • Press and hold on the battery for 10 seconds to bond the adhesive.

  4. LOUbhqP2TKPifCCx
    LOUbhqP2TKPifCCx
    rRVDfbPIADlEd3KX
    soASocpeZtCHYCnP

    • Hold the release button so its smooth face is perpendicular to the controller.

    • Insert the release button into its bracket.

    • If the release pin doesn't stick out of the controller when the button is pressed, the button isn't installed correctly. Re-insert or flip the button and try again.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Nick Schultz

Membro desde: 24/03/24

45909 Reputação

0 comentários