Left Joy-Con 2 Back Cover Installation

Escrito Por: Nick Schultz

Comentários: 2

Dificuldade

Moderate

Passos

Tempo necessário

No estimate

Introdução

Passo 1

Align the battery connector over its socket on the board.
Press down on the connector until it's fully seated.

Passo 2

Align the rumble motor connector to its socket on the bottom edge of the board and push down until it's fully seated to connect it.

Passo 3

Use an opening pick to press and hold the release button.
Place the back cover over the controller body so the release button cutout is slightly below the release button.
The release button is held down when the release pin is protruding from the frame. If the release button falls out of position, put it back and try again.
Press and slide the back cover up until the cutout for the release button is aligned with the button itself.
Ensure the rumble motor wires (blue & white) are fully within the frame.

Passo 5

Install the two screws on the left edge of the controller:
One 3.1 mm‑long tri‑point Y00 black screw
One 3.0 mm‑long JIS 00 silver screw

Passo 6

Align the clips on the plastic strip with their cut-outs on the controller body.
Insert the clips on the bottom edge first, then insert the rest so the plastic strip sits flush.

Passo 7

Use a tri‑point Y00 driver to install the two 3.1 mm‑long black screws on the right edge of the controller.

How do the joy cons operate when physically connected to the switch 2 in handheld mode? Do the joycons rely on a Bluetooth connection at all times? Is the connection when paired to the switch 2 still using Bluetooth? Or is the connection physical when the joycons are physically connected? I am curious.

Alen K -

Thanks for the very clear and helpful guide. My thumbstick sheared off the controller and this was perfect and easy to follow.

Jaydan Thorpe -