Lefant M210 Wheel Assembly Replacement

Escrito Por: Adrian pg
  • Comentários: 0
Lefant M210 Wheel Assembly Replacement

Dificuldade

Moderate

Passos

6

Tempo necessário

20 - 40 minutes

Introdução

This guide provides step-by-step instructions for replacing the wheel assembly on the Lefant M210 robot vacuum.

  1. hxtPpCmZYRXByvvA
    hxtPpCmZYRXByvvA
    TkSTDccBkxp2SXve

    • Turn off the Lefant M210 and disconnect it from the charging dock.

    • Flip the unit over so the bottom faces upward.

    • Locate the circular brush assemblies on the left and right sides of the underside.

    • Place the unit on a clean, flat surface to prevent scratching.

  2. vlQceXhE1r1kMM5a
    vlQceXhE1r1kMM5a
    EpBeJrcoPnFBFdaW
    aWQxLHpaquDDGkkT

    • Insert the iFixit Opening Tool (or similar pry tool) under the circular edge of the brush assembly.

    • Apply gentle downward pressure on the opposite end of the tool to lever the brush component out of its housing.

    • Remove the brush assembly completely and set it aside.

    • If replacing both brush assemblies, repeat this process on the other side.

    • Avoid using excessive force, which may damage the mounting clips.

    • Position the new brush assembly above the square mounting peg.

    • Align the square cavity on the bottom of the brush with the corresponding square peg in the vacuum housing.

    • Press down firmly on the brush assembly until you hear or feel it click into place.

    • Gently tug on the brush to verify it is securely seated.

    • The brush should sit flush with the housing and not move when pulled gently.

  4. Zqk6gIHxJmdwCqpW

    • Use a Phillips screwdriver to remove four screws near each wheel.

  5. 15pWyj44ycVQtDyB
    15pWyj44ycVQtDyB
    sYBEsOhQWCBRXKZ5

    • Remove the plastic cover next to each wheel.

    • Grip both sides of the wheel and pull upwards.

    • The wheels of the device require some force to remove.

    • Don't pull the wheels too hard as they are attached to cables and may be damaged if yanked.

  6. BMWeYMhJZwUWDeMA
    BMWeYMhJZwUWDeMA
    mE5NGmcVusnICMlZ
    FjYfHF1xX3mP2xC6

    • Hold the wheel up and detach the connector to release it from the device.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Adrian pg

Membro desde: 09/09/24

147 Reputação

0 comentários