Introdução

Is your Lite FX Rotating Big Ball of Lite Model 1929 disco ball screeching instead of spinning out those groovy vibes? Don’t let the noise ruin your party! A little TLC—specifically greasing the gears—can bring back the smooth rotation and dazzling light show. This guide will walk you step-by-step through accessing and lubricating the gear so you can keep the party going without a hitch. Let’s fix that screech and get back to the groove!

  1. FhjGNX2lBvwADUKG
    • Turn the device over so that the base is facing up.

  2. GwdTEfKHTy2djhbI
    • Peel off the piece of metal that is glued to hold the two halves of the base together.

    • You may need to reapply glue to the piece of metal when reassembling the device.

  3. DldoLmME1QWelBjD
    DldoLmME1QWelBjD
    Kk6hCiIxmtvUVLv1
    • Unscrew the four 10mm Phillips head screws on the bottom of the device.

    • Once the base is removed, the device should look as shown on the picture.

  4. rYaJfqxWIH1tfGVG
    rYaJfqxWIH1tfGVG
    HyvRGA5jZMOF6gGh
    • Use a pair of tweezers to crush the sides of the wirenuts.

    • The wirenuts are crimped to lock the wires in place. Usually the wires are just twisted into them.

    • Pull all of the wires out of the wirenuts.

  5. TlB4WR1qFFXCdaGy
    TlB4WR1qFFXCdaGy
    s5IXetfH5CrE5EbS
    • Separate the wires that belong to the motor.

    • The wires should be small and black.

    • Remove the motor.

  6. ZYL6J5P6YOLR3xe1
    • Remove the two 10 mm Phillips #1 screws.

    • Remove the center 14 mm Phillips #1 screw.

    • Remove the plastic piece stabilizing the gear.

  7. NwJAiKrlRCXS6WQp
    • Gently apply oil to the gear using a Q-tip.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Nick Kaprielian

Membro desde: 14/01/14

531 Reputação

0 comentários