Introdução
If your RV toilet sprays water outside the bowl when flushing, the water pressure may be too high. Installing a water pressure regulator will reduce the toilet’s pressure without lowering water pressure to the rest of your RV.
This repair is straightforward and doesn’t require special skills, but you will need to know how to turn off the RV’s water supply before starting. Some regulators include a wrench and hex key, so check before buying extra tools. Refer to your RV manual for details about your specific system.
Ferramentas
Peças
-
-
Wrap the thread tape around the 1/2" nipple, 2-3 times in a counter-clockwise motion.
-
Make sure the nipple is fully covered, but the ends are open.
-
-
-
Screw the nipple onto the regulator, making sure the arrow (marked by the red circle) is pointing away from the nipple.
-
-
-
Wrap the thread tape around the pressure gauge 2-3 times, in a counter-clockwise motion.
-
Do not thread the gauge in yet. Instead, note the angled slot where it will be installed in step 10.
-
-
-
Turn on the sink faucet and let it run until no more water comes out to drain the lines.
-
Flush the toilet to drain any remaining water in the lines.
-
-
-
Screw the pressure gauge onto the regulator.
-
Tighten it all the way down as far as you can with finger strength.
-
-
-
Take the Allen Key and insert it in the top of the regulator.
-
Twist the Allen Key while running water into the toilet until the desired water pressure is achieved.
-
To reassemble your device, follow these instructions in reverse order.
