Geek Bar Pulse Tank Cover Replacement

Grasp the mouthpiece with a pair of pliers.

Give it a good, solid twist, left or right doesn't matter.

Hopefully the mouthpiece seal stays in place when you removed the mouthpiece, but it doesn't always. If it has come off, you need to know how to replace it.

It is inserted into the mouthpiece with the felt piece up. Putting it in the other way will not allow for an airtight seal between the tank and the mouthpiece.

Note that the mouthpiece has a tab that only allows it to be mounted in one orientation. The arrow here points to the one you'll need to match up with on the case.

Here you can see inside the case where the tab on the mouthpiece lines up.

Turn the power switch to the Off position; no air holes should be visible.

Use your utility knife to lever the power button up. It is only pressed on, so there is no adhesive or clips to deal with.

Remove the power button.

Position your thumbnail on the seam near the bottom of the vape.

Work your utility knife into the two high points of the case on the bottom.

Pry the near side of the case far enough open to get your fingernail into the gap to keep it open.

Insert your knife and slide it down, then use it to lever the top of the vape out of the case.

Using the knife, go back to the bottom and lever the opposite side out.

On the other side, insert the knife and use it to pop the clips on that side.

The clips should be free all the way around at this point.

Pull the vape straight out of the case.

The cover has been removed.