Introdução
This guide explains how to replace the right bumper (RB) on the GameSir X2s Type-C.
The right bumper is used for secondary commands such as switching weapons or activating abilities. A faulty bumper can lead to missed inputs and reduced usability.
Ferramentas
-
-
Use a 000 Phillips screwdriver to remove the following eight silver fine-thread 6mm screws.
-
Flip the controller upright.
-
-
-
Remove the four silver fine-thread 4.5mm screws under the rubber grip using the 000 Phillips screwdriver.
-
Flip the GameSir X2s Type-C to the back.
-
Using a prying tool around the lip, where both pieces of plastic meet, run that around the hold device.
-
Pop off the plastic piece attached to the device.
-
-
-
Remove the blue strip connected to the board.
-
Remove six silver fine-thread 4.5mm screws and the two black fine-thread 4.5mm screws using a 000 Phillips screwdriver.
-
Remove the gold strip connected to the board.
-
-
-
Remove the three black fine-thread 4.5mm screws using the 000 Phillips screwdriver.
-
Remove the red and black wires from the board.
-
Remove the board from the GameSir X2s Type-C.
-
-
-
Remove the 3 black fine-thread 4.5mm screws from behind the right trigger using a 000 Phillips screwdriver.
-
Remove the 3 black fine-thread 4.5mm screws from the board using a 000 Phillips screwdriver.
-
Remove the red and black wires from the board.
-
To reassemble your device, follow these instructions in reverse order.
