GameSir Cyclone 2 Joystick Covers Replacement

Escrito Por: JasmineM
  • Comentários: 0
GameSir Cyclone 2 Joystick Covers Replacement

Dificuldade

Moderate

Passos

5

Tempo necessário

15 - 25 minutes

Introdução

Follow this guide if you need to replace the joystick covers of your GameSir Cyclone 2 controller.

  1. ThaKjTxgJTDrniuG
    ThaKjTxgJTDrniuG
    llgJCn3A61hDtpSq
    OjSn2oUcERRKJcJk

    • Use a T6 Torx to remove seven screws from the bottom of the controller.

    • The last screw is under the sticker. Lift the sticker with tweezers, then then remove the final screw.

  2. 6jkhrKTUpXsXaQ6Z

    • The two larger screws belong on the top two sockets of the controller

  3. WDQCwrdoDBjDx1uW

    • The remaining five sockets in these locations

  4. euvnAXorXLUp5tDN
    euvnAXorXLUp5tDN
    cAKKtlDlSFJE6PdF

    • The front plate should pop with minimal force with the D-Pad and action buttons becoming loose as well.

  5. HwLpXQKjutETLtoF
    HwLpXQKjutETLtoF
    CJuWMwmjtSKoJoJv
    drH2eIevsY61oXUr

    • Pull both joystick covers straight up to remove them from the controller.

Conclusão

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler.

Autor(a)

JasmineM

Membro desde: 15/10/25

373 Reputação

0 comentários