GameSir Cyclone 2 Battery Replacement

Use a T6 Torx to remove seven screws from the bottom of the controller.

The two larger screws belong on the top two sockets of the controller

The remaining five sockets in these locations

The front plate should pop with minimal force with the D-Pad and action buttons becoming loose as well.

Pull both joystick covers straight up to remove them from the controller.

once the face plate is off locate the top bumpers

The top bumpers are connected to the power button which you can just pull apart after removing two screws with the "00" Phillips bit

remove the bumpers and replace with the new set you have aquired

Now locate the 2 black boxes twards the bottom of the contoller

you need to remove the 2 boxes they should snap right off with a upward motion

Once the boxes are off of the controller there are 2 clear cylinder shaped objects that spread the led light through the controller

remove thoes strips and replace with new ones

Under each LED track are two screws that need to be removed to remove the board.

Remove center screw to remove motherboard

Disconnect the battery connector from the socket on the motherboard.

Remove the battery.