Framework Laptop 16 Speakers Replacement

Unplug all cables and fully shut down your laptop.

Use your fingernail to pull out the two Input Module latches and unlock them.

Use your fingers to slide the Touchpad Spacer toward the bottom edge of the laptop and unclip it.

Lift the Touchpad Spacer off the laptop and remove it.

Repeat the same procedure for the other touchpad spacer.

Use your fingers to slide the Touchpad Module toward the bottom edge of the laptop and disconnect it.

Lift the Touchpad Module and remove it.

Grip the two pull tabs along the bottom of the keyboard and lift until its magnets release.

Remove the keyboard.

Grip the pull tab at the bottom of the Input Module and lift until its magnets release.

Remove the Input Module.

Repeat for any remaining Input Modules.

Grip the black pull tab on the Mid Plate cable press connector.

Lift up to disconnect the Mid Plate cable.

Use your Framework Screwdriver to loosen the 16 captive T5 Torx screws securing the Mid Plate.

Use your fingers to lift the Mid Plate off the laptop and remove it.

Use your Framework Screwdriver to loosen the three captive T5 Torx screws securing the battery.

Grip the black pull tab at the top of the battery and lift to disconnect the battery connector.

Remove the battery.

Lift the speaker cable connector by its black pull tab and disconnect it.

Starting at one speaker, use the flat end of a spudger, or your fingers, to lift the speaker cable out of its rubber clips.

Slide the speaker cable out from under its screw hole peg in the frame.

Repeat the last two steps across the length of the speaker cable until it's completely unclipped.

Use your Framework Screwdriver to remove the two 2.0 mm‑long T5 Torx screws securing each speaker (four in total).

Lift the speakers off their alignment pegs and remove them.

Congratulations on completing disassembly! The remaining steps will show how to reassemble your Framework Laptop.

Align the speakers over their alignment pegs and press them down into place.

Use your Framework Screwdriver to install the two 2.0 mm‑long T5 Torx screws securing each speaker (four in total).

Use the flat end of your Framework Screwdriver to push the speaker cable back into its clips along the bottom edge of the laptop.

Press the speaker cable connector onto its socket to connect it.

Align the battery connector over its socket and lay the battery into its well.

Lightly press the battery down to connect it.

Use your Framework Screwdriver to tighten the three captive T5 Torx screws securing the battery.

Place the Mid Plate on the laptop, making sure it sits evenly on its alignment pegs.

Use your Framework Screwdriver to tighten the 16 captive T5 Torx screws in order (starting with 2) to secure the Mid Plate evenly.

Align the Mid Plate cable press connector over its socket and press down to connect it.

Grip the pull tab at the bottom of the numpad.

Lift the pull tab until the numpad magnets release.

Remove the numpad.

Align the top edge of the keyboard with the top edge of the laptop.

Lay the keyboard on the laptop and let the magnets pull the keyboard into place

Place the Touchpad Module flat on its cutout so its clips are properly aligned.

Press the Touchpad Module down and slide it into place so it lines up evenly with the bottom edge of the laptop.

Place the Touchpad Spacer over its spot on the laptop with the bottom edge overhanging slightly.

Slide the Touchpad Spacer towards the top of the laptop to secure it.

Repeat the same procedure for the other Touchpad Spacer.