DualSense Edge Front Trim Replacement

Escrito Por: Spencer Pennington
  • Comentários: 1
DualSense Edge Front Trim Replacement

Dificuldade

Very easy

Passos

1

Tempo necessário

1 minute

Introdução

Follow this guide to replace, change, or upgrade the front trim on your Sony DualSense Edge controller.

Ferramentas

  1. x4vwaRsDyyrnGO1H
    x4vwaRsDyyrnGO1H
    GqAfoBfvBQYJpSEc
    HBjKPWcMs4BNEHWD

    • Place the controller on a work surface with the joysticks facing down.

    • Use a spudger or your finger to slide the Release tab to the left. The front trim should fall to the table.

    • If the front trim doesn't fall open, make sure the front trim has room to fall down and the Release tab is pushed all the way to the left.

    • Lift the controller up, leaving the front trim on the table.

    • During reassembly, insert the front trim at an angle so the top slots in first, then lower the trim into place and snap it onto the controller.

    Where do you get the replacement parts for the trigger assembly and ribbon cables?

    Rocco Laurie -

Conclusão

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Autor(a)

Spencer Pennington

Membro desde: 09/09/23

24512 Reputação

0 comentários