Introdução
This disassembly guide takes you through the MP-01 by the Minimal Company
-
-
It's not possible to disassemble the phone through the approach from the back.
-
A heat pad is recommended for weakening the glue.
-
Use a suction cup and thin spudger to separate the back. The back is ultra thin plastic, so be gentle with it.
-
-
-
The camera in this housing is loose. The rattle of the front and rear camera, coupled with the line in the screen prompted initial disassembly. Fix the rattle by using a piece of double sided-adhesive tape when you place the camera back in its housing.
-
-
-
If your disassembly goes anything like this, there is a TON of glue. Recommend cleaning using adhesive remover and reapply T-7000 as needed.
-
-
-
Remove bottom two screws. Annoyingly these use a different bit.
-
there are 5 screws that attach the assay to the board
-
To reassemble your device, follow these instructions in reverse order.
