Closing the earbuds

Escrito Por: Byte Hoarder
  • Comentários: 0
Closing the earbuds

Dificuldade

Easy

Passos

6

Tempo necessário

15 minutes

Introdução

This guide shows how to close the earbuds again.
As the adhesives used set rather quickly it is recommended to read the whole guide first!

    • Clip the two halfs together to check that there isn't any old glue or wires in the way.

    • There should be absolutely no seam if you press them together slightly

    • Separate them again before continuing with the assembly.

  2. VHIUqRfYKStWHML5

    • The cover over one of the mics likes to come of. Make sure it's in the right place before going on with closing the earbuds.

  3. MfAHOkCUrOfYoime

    • While it is possible to apply glue while holding the top half it's recommended to put the top half on a stick (or scalpel) with some sticky puddy.

  4. VjRAntbbMwBOPZMi

    • As the original adhesive for the pins is a flexible one it is recommended to use something similar like B7000 for them.

    • This makes future disassembly easier if needed.

    • Super glue can be used as well if this is not of concern or a fitting adhesive isn't available.

  5. TQowI31blxkspmfA

    • Put down a thin bead of super glue in the groove of the seam.

    • Check for the mic cover one last time.

    • Align the two half before quickly pressing them together.

    • Make sure to keep your fingers away from the seam as super glue might squeeze out.

    • Use a bit of pressure to make sure the seam is fully closed and hold it for 15s to get the glue time to set.

Autor(a)

Byte Hoarder

Membro desde: 03/07/25

535 Reputação

0 comentários