Introdução
This is a comprehensive guide to replacing the microphone of the CAT S62 phone.
Symptoms of a malfunctioning microphone are:
- The other party cannot hear you during phone calls.
- No sound or very quiet sound is recorded when using a voice recorder app or recording video.
- Your voice sounds choppy, distant, or "underwater" to the person on the other end of the line.
-
-
Use the plastic spudger to gently pry off the rubber back panel. If needed, use the plastic iFixit opening picks to help keep the plate separated. (Heating the back of the phone using a blow dryer may help loosen adhesive.)
-
Gently pull the back panel away to avoid damaging the connecting wire for the fingerprint sensor.
-
-
-
Gently remove the wire connecting the back cover to the rest of the phone using your fingers or tweezers.
-
-
-
Remove the eleven 5mm screws with a JIS #00 screwdriver.
-
Remove the six 3mm screws (three screws on each side) with a Hex 1.3 mm screwdriver.
-
-
-
Use a blow dryer or other heating device for a few minutes to loosen the adhesive beneath the battery.
-
Pry the battery away using the plastic spudger and iFixit opening picks.
-
-
-
Flip the speaker over and locate the silver circular microphone.
-
Insert the pencil end of the spudger underneath the microphone and pry it up.
-
Carefully pull the bronze colored microphone cable upwards to remove it.
-
-
-
Use tweezers or your fingernail to wedge underneath the silver bit and pull with some force, as it is glued in.
-
To reassemble your device, follow these instructions in reverse order.
