Black and Decker BL3000S Motor Fan Replacement

Escrito Por: Andrew

Comentários: 3

Black and Decker BL3000S Motor Fan Replacement

Dificuldade

Moderate

Passos

Tempo necessário

5 - 10 minutes

Introdução

Upon completion of this guide, you can successfully install and replace the motor fan for you blender.

Ferramentas

Passo 1

Before disassembling the blender base, make sure the blender disconnected from any power outlet.
Lift the jar straight up from the base without tilting the jar.

Passo 2

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Passo 3

Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.
This provides access to the base screws beneath.

Passo 4

Remove the following screws that secure the top and bottom halves of the base.
One 1/4 Phillips screw
One TA-20 screw
Both screwdrivers must have a minimum of a three inch shank (length).
Screwdrivers with extenders will not fit down the access holes.

Passo 5

Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Ja, en nu hoe repareer ik de blender motor, 400 watt

Deze is waarschijnlijk doorgebrand. Ik heb hem wel stil gezet toen er rook uitkwam, hij is dus niet beveiligd, maar dat heeft niet geholpen. Uiteindelijk is ie ermee gestopt. Het is een sokany 400 watt

olijfjes -

Ik heb niet meteen zo’n mooi printplaatsje visueel als ik deze openmaak, maar de ventilator.

olijfjes -

Passo 6

Using pliers, remove the top nut from the fan and remove the washer.
Use a small towel to hold the fan in place. This makes taking off the nut easier to do.

Passo 7

Lift the fan blades from the blender base.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Andrew

Membro desde: 05/10/12

323 Reputação

Um comentário

mon mixeur a montre des itincelles et de la fumeé quel étape puis suivre pour le réparer

abdelkarim hassi -