Introdução
While many repairs can be accomplished without soldering, there are times when it's necessary to replace certain components, e.g., on switches and heater coils. An On Switch may need to be replaced if when flipping the switch back and forth, it does not turn the curler on. It may seem very technical and complicated, however, it is simpler than it seems.
-
-
Using an opening tool, insert it along the seam where both halves of the casing meet, and slowly pry the left side of the casing from the right.
-
Gently pull back the right side of the casing from the center molding.
-
-
-
Release the securing tabs on the switch to the center molding.
-
Use a 4mm flat head screwdriver to break off the solder where the wires meet the switch.
-
-
-
Press the new switch back into the center molding and use a soldering iron to solder the wires on the new switch.
-
To reassemble your device, follow these instructions in reverse order.
