Beats Pill 2024 Subwoofer Replacement

Escrito Por: Spencer Baines
  • Comentários: 0
Beats Pill 2024 Subwoofer Replacement

Dificuldade

Moderate

Passos

7

Tempo necessário

20 - 25 minutes

Introdução

This guide gives details about how to replace the subwoofer in the 2024 Beats Pill. A subwoofer replacement might be needed after an unsuccessful troubleshooting of gargled sound or absence of bass in the speaker.

  1. pljco5HcSCYTsCbp

    • Remove the strap.

  2. M2FE2yoLpgQgg1aB
    M2FE2yoLpgQgg1aB
    mibPrdZAVNvqd3Bu

    • With the Beats Pill sitting on a flat surface, insert a spudger into the seam between the chassis and grille.

    • Slide the spudger around the entire perimeter of the grille to sever the adhesive securing the grille.

    • Reapply adhesive when reinstalling the grille.

    • Remove the grille.

  3. GtBNeFbPQ1WEkgJj
    GtBNeFbPQ1WEkgJj
    pLjH1JVwpwWY62ZN

    • Use a spudger to remove the six stickers on the face of the driver assembly.

    • Place the stickers on a clean surface so as not to ruin the adhesive.

  4. VE5Eh2lnaYBSCFWi

    • Use a Phillips #1 screwdriver to remove the six 14.3 mm screws that secure the driver assembly and speaker body together.

  5. oqspt2iWduhuBY5c
    oqspt2iWduhuBY5c
    sDkyWXXRhTsHCdtm

    • Insert a spudger into the seam between the driver assembly and speaker body.

    • Gently slide the spudger around the perimeter while prying to separate the driver assembly from the speaker body.

    • This should not require much force.

  6. LWyYP6yBVXVJTwjc

    • Disconnect the two subwoofer connections from their motherboard sockets.

    • Depress the clip on each connector prior to removal.

    • Use tape or a marker to mark where each connector goes.

    • If you're completing a tweeter replacement, skip to Step 8.

  7. 1wJ3UnjjiZeQAZHJ

    • Use a Phillips #1 screwdriver to remove the four 12.4 mm screws securing the subwoofer.

    • Use a spudger to lift the subwoofer up and off of the driver assembly.

    • This might require some force, as there is adhesive holding the subwoofer to the assembly.

    • During reassembly, apply an adhesive to the new subwoofer before reinstallation.

Conclusão

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.

Autor(a)

Spencer Baines

Membro desde: 23/01/25

753 Reputação

0 comentários