Introdução
In this guide, we'll show you how to replace the audio speaker in your Acer Chromebook Tab 10 N18Q1 tablet.
If your speaker sounds faulty or there is no audio output, check the troubleshooting pages first if you haven't to confirm your tablet needs a new speaker.
The tablet speaker is placed within a few pieces of hardware. In this guide we will show you how to remove each layer of hardware to access and remove the speaker.
The speaker is the sound box of the Acer Chromebook Tablet; it plays any recorded sound of your choice on your tablet.
Before you begin the repair, make sure your tablet is powered off and disconnected from the charger.
-
-
Insert an opening pick into the gap between the screen and the bottom case. Slide it around the edge to release the clips securing the two parts together.
-
Gently separate the screen from the bottom casing.
-
-
-
Use a spudger or a clean fingernail to flip up the locking flap—this is the unlocked position.
-
Use tweezers or your fingers to gently pull the cable out of its socket.
-
Remove the sensor board and cable.
-
-
-
Use a Phillips #1 screwdriver to remove the 2 screws holding the USB-C port in place.
-
Remove the screw at the end of the orange ribbon cable and remove the USB-C cable.
-
-
-
Use a Phillips #0 screwdriver to remove the 2 screws from the lower speaker.
-
Remove the lower loudspeaker.
-
-
-
Remove the two Phillips screws from the upper speakers that secure them to the frame.
-
Remove the upper speakers.
-
To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler.
