2009 Honda Fit Brake Switch Stopper Replacement

Escrito Por: Theresa
  • Comentários: 0
2009 Honda Fit Brake Switch Stopper Replacement

Dificuldade

Very easy

Passos

5

Tempo necessário

4 minutes

Introdução

Model: 2009 Honda Fit Sport GE8

Guide Purpose: Brake Light stopper replacement

Parts Description: The part is a small plastic piece used to stop the brake from being engaged when not being pressed.

Reasons for guide: Brake light stuck on, causing the battery to drain overnight.

  1. LteGcgPU1kVI6yAh
    LteGcgPU1kVI6yAh
    1LHDWFDHJtvBS5K4
    OdcNl1KAteKTWwEC

    • Remove the panel protecting the pedal system. It will be under the steering wheel just above the pedals.

    • Rotate the plastic latch a quarter turn clockwise.

    • The subsequent images show it locked and then unlocked

  2. N331QFDOwBI2AQ6M
    N331QFDOwBI2AQ6M
    l5DspJYdIcDpIRxH

    • The plastic cover will be hanging on by a friction clip on the right side.

    • Grab the piece with both hands and pull down and out on the panel.

  3. qsDiZBREiNqnAwmJ
    qsDiZBREiNqnAwmJ
    VjBy1JrmyUTS5qjH

    • Check that you are in park with the handbrake engaged and start the car.

    • This allows for the brake pedal to be pushed easily with your hands.

  4. cF6HLtCQRGO1WYia
    cF6HLtCQRGO1WYia
    aIObZwZZYMlmjvX5

    • This piece is hard to remove (when not broken) so the example is kind of off, though where you see the red circle is where the replacement piece has to go.

    • Push in the brake so you can insert the stopper, using force to push the stopper in place.

  5. IRME2XYW5gfudukl

    • Make sure the brakes work and turn off properly.

    • Follow steps 1 and 2 in reverse.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Theresa

Membro desde: 24/09/25

121 Reputação

0 comentários