2002-2006 Honda CR-V Tail Light Bulb Replacement

Escrito Por: Anas Alaoui
  • Comentários: 3
2002-2006 Honda CR-V Tail Light Bulb Replacement

Dificuldade

Easy

Passos

6

Tempo necessário

10 - 15 minutes

Introdução

This guide shows the process for replacing a tail light bulb on a Honda CR-V 2002-2006, whether it is a turn signal, a brake light, or a reverse light. Bulbs have a life span and need to be replaced if fused or malfunctioning for personal and others' safety. Moreover, properly working tail lights is the legal responsibility of every driver. Replacing a tail light bulb on a Honda CR-V 2002-2006 is easy and knowing how to do it can save the driver time and a fair amount of money.

  1. WUJMGuUqqwybEraG

    • Open the trunk door.

  2. 3KvSJMZfIHILXGHB
    3KvSJMZfIHILXGHB
    4SvZXDh5pLcELEIS

    • Remove the tab covering the screws using the flat-head screwdriver.

  3. yQ5XRPri1ysWAhC5
    yQ5XRPri1ysWAhC5
    mgCSvoJmLO3Qvqlf

    • Remove both screws using the Phillips screwdriver.

  4. TZqqUOJbxTEJnYdd
    TZqqUOJbxTEJnYdd
    ku55Uh4oCQ5QuN1M

    • Take off the tail lamp assembly by slightly pulling the low end using one hand.

    • Slide down the lamp a little bit and pull it off using both hands to separate it from its base.

  5. EbvpuRACQMj2EXAr
    EbvpuRACQMj2EXAr
    sYjFQQGjULk4ZLs1

    • Remove the bulb socket by making a ¼ counterclockwise twist.

  6. VaE2kmyUwoHLsfff
    VaE2kmyUwoHLsfff
    CULSiImbsnPEoOHK

    • Remove the bulb from its socket by making a ¼ counterclockwise twist.

    My 2004 CRV uses 7443 bulbs for the brake/tail lights, not the 1156 bulbs mentioned at the top of the article. The bulb sockets are different than those pictured here.

    Socket pic. Excuse the dirt.

    Ebby -

Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

Anas Alaoui

Membro desde: 17/01/22

187 Reputação

2 comentários

This does not tell people how complicated it is to change the right side. That they need a 5/16 ratchet. That is a big deal for women

Bettrina Truitt -

I found it trivial to use a cheap-ola 8mm nut driver to reach all bolts. Just open the rear door 95% open so it swivels out of the way and you can access the last bolt straight on from the outside.

Ebby -